 |
Updating A Superclip 1 or a Superclip2 |
|
| |
|
| |
|
|
Make sure you have downloaded
and installed the USB drivers first, and installed yourSuperclip
on your PC. |
| |
You can not update your superclip with
out doing this first, always install drivers first for
USB devices before connecting them to your PC for the
first time. |
| |
|
|
Follow the instructions on updating
your clip below |
| |
(use the relevant set depending on your
clip is blank or already has an update installed) |
| |
|
|
Updating A Blank
Clip (flashing LEDs) |
 |
A blank clip has all 4 LEDs flashing in
a fast sequence. Use the following sequence for updating
a Blank Clip !!!! |
| |
|
| |
1. Power up the clip by pressing the “Select”
button
2. Start the Updater SW (if it is not running already)
on your PC.
3. Connect the superclip to your PC, using a Type A-Male
to Type A-Male USB cable.
4. All LEDs will change and LED 1 will remain on.
5. The message on the Updater SW will change from “Please
Connect The Super Clip” to “Super Clip Connected”
6. Click on the Updater Software the “Enter”
button
7. The Updater SW will now update the Clip. |
| |
 |
| |
8. Once the clip is updated press and hold “Select”
button for about 1 second to turn the superclip off
9. Disconnect from USB cable
10. The clip is now updated |
| |
|
|
Updating A Loaded Superclip (steady lit LEDs) |
|
This is a superclip that has already previously had
an update installed. |
| |
|
| |
1. Make sure you have installed the latest Superclip
updater installed, you can download this from www.superclip.co.uk
2. Power up the clip by pressing the “Select”
button
3. Start the Updater SW (if it is not running already)
on your PC
4. Connect the superclip to your PC, using a Type A-Male
to Type A-Male USB cable.
5. Press and hold the “select” and “enter”
buttons on the superclip, LED 1, should remain lit,
LEDs 2, 3 & 4 should cycle up and down.
6. Release the buttons
7. Now press the enter button on the clip, LED 1 should
now remain lit.
8. The message on the Updater SW will change from “Please
Connect The Super Clip” to “Super Clip Connected”
9. Click on the Updater Software the “Enter”
button
10. The Updater SW will now update the Clip.
|
| |
|
| |
11. Once the clip is updated press and hold “Select”
button for about 1 second to turn the superclip off
12. Disconnect from USB cable
13. The clip is now updated |
| |
|
| |
|
