| |
|
 |
Updating The SuperClip Firmware |
 |
Some updates require the firmware in
the superclip to be updated. You will be advised if this
is neccesary when the update is released. |
|
|
| |
1. Install the New update.
2. Run the newly installed Updater.
3. Connect the Clip to computer with the USB A to A Cable.
4. Press enter on the clip and LED 1 should light.
5. Now Click on the enter button on the Software.
6. After the clip has updated. |
| |
THE NEXT PART IS
VERY IMPORTANT AND MUST BE DONE RIGHT
THIS WILL ONLY HAPPEN ON THE FIRST UPDATE
UPDATING AGAIN WILL NOT UPDATE THE FIRMWARE AGAIN |
|
| |
7. Turn off the Clip by Holding the SELECT button for
1 secondthen releasing it.
8. Now Disconnect the clip from the USB Cable.
9. Once Disconnected Press the SELECT Button LED 1 Should
Flash.
10. Press the SELECT Button Once more and now LED 4 Should
Flash.
11. Now Press Enter. (Firmware is now Updated) |
| |
|
| |
|
